Energy UNITS FOR LIFT TABLE 1
Common Description
This electrical power unit is created solely for your smaller lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has become broadly used inside the marketplace of logistic products which include minifork lift, scissors lift and ariel working platforms. The lower-ing motion is controlled through the solenoid valve with the pace managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Basic Description
This energy unit is made solely to the medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve along with the pace managed from the adjustable needle valve. Once the lift rises to a higher positoin, however the energy supply is cut, the decreasing motion is managed through the guide override perform.
Power UNITS FOR LIFT TABLE three
Basic Description
This energy unit is created solely for the huge lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve plus the velocity managed by a stress compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This power unit is developed exclusively for your substantial lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve as well as pace controlled from the adjustable needle valve. Once the lift rises to a high positoin, but the energy provide is reduce, the lowering motion is managed through the manual override perform.
Specific Notes
one. This power unit is of S3 duty cycle, which could only operate intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean the many hydraulic parts concerned prior to set up of the energy unit.
3. Viscosity of the oil shoud be 15~46 cst,which should really also be clean and totally free of impurities.N46 hydraulic oil is recommended.
four. Oil changing is required after the original a hundred operation hours,afterwards once each and every 3000 hrs.
five. The energy unit 
proven is intended to be mounted vertically.